I have a problem withhitting table with my racket edge & it chips.
How can I protect the edges
How to protect racket edges
-
Rhys Shadine
- Posts: 1
- Joined: August 31st, 2022, 11:39 pm
- Country: Jersey
- City & State: Saint Brelade
- Playing Style: ..
- Grip: ..
- Cohort: .
- My blade:
- Blade Type: .
- Side F rubber brand:
- Side F rubber type: .
- Side B rubber brand:
- Side B rubber type: .
- Orientation: .
Re: How to protect racket edges
When I get a new blade, I epoxy all around the edges. Then I also epoxy the throat of the blade about 4 mmboth sides & make sure it meets & connects the area where the eadges end on both sides.
I do this because I had some blades have the handle break off at the throat from rackethead.
Then I tape all around the edges as well using an insulation tape & such similar tape
It does make the blade little stiffer & adds a few grams but I am willing to live with that.
I do this because I had some blades have the handle break off at the throat from rackethead.
Then I tape all around the edges as well using an insulation tape & such similar tape
It does make the blade little stiffer & adds a few grams but I am willing to live with that.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 1181 Views
-
Last post by popete59
-
- 6 Replies
- 2902 Views
-
Last post by Stofoulos
-
- 1 Replies
- 2557 Views
-
Last post by BrianM
-
- 1 Replies
- 6076 Views
-
Last post by Kevylvin
-
- 2 Replies
- 4568 Views
-
Last post by N0ppenfreak999
-
- 3 Replies
- 27448 Views
-
Last post by Yomek
-
- 5 Replies
- 3544 Views
-
Last post by James Z
-
- 1 Replies
- 1236 Views
-
Last post by James Z
-
- 2 Replies
- 2258 Views
-
Last post by Thiptawan
-
- 0 Replies
- 2189 Views
-
Last post by Power Spin