iocTT.com :Most advanced multi-lingual discussion forum for tabletennis (Factual / parody). Uncensored. Free discreet membership to post. Simple registration. No email needed.

Posted: **May 5th, 2026, 10:42 pm**

Iwas looking at this page on dealer website
https://tokspin.com/product/sauer-troge ... opilot.com

It says the pip height is 2.15 mm
How could it be ITTF approved ?
The maximum allowed pip height is 2.05 mm (Was 2.00 mm till 2024)

See attachments

Posted: **May 5th, 2026, 10:53 pm**

Pip density = 10 pips per sq.cm
That is the lowest ITTF allowed.
If the pips are that far apart , then this is not not for away from the table choppers, since it is a fast at the table blocking rubber

Posted: **May 5th, 2026, 10:56 pm**

If the pip height is too high for ITTF approved then I might as well use Mo Wang 3 rubber

https://www.aliexpress.us/item/3256810547860681.html

https://www.google.com/search?as_q=&as_ ... &authuser=

iocTT.com :Most advanced multi-lingual discussion forum for tabletennis (Factual / parody). Uncensored. Free discreet membership to post. Simple registration. No email needed.

Is Sauer & Tröger SCHMERZ really ITTF approved?

Is Sauer & Tröger SCHMERZ really ITTF approved?

Re: Is Sauer & Tröger SCHMERZ really ITTF approved?

Re: Is Sauer & Tröger SCHMERZ really ITTF approved?